Stochastic evaluation of leakages through holes in wrinkle networks of composite liners

This paper presents a study on stochastic evaluation of leakages through holes in wrinkle networks of composite liners. The statistical parameters of wrinkles are used as indexes to describe the spatial distributions of wrinkles in a wrinkle network and the wrinkle density is modeled as a random field in the proposed approach, which allows the construction of a database about how wrinkles may be distributed in different conditions and provides input parameters for leakage evaluation at the design stage when the site has not been constructed yet and the aerial image of the wrinkle network (AWN) is unavailable. Statistical analyses were performed on wrinkle geometric parameters and wrinkle density of wrinkles from three sites reported in the literature. The procedures of generating random wrinkle networks (RWNs) based on the statistical parameters of wrinkles are introduced. The proposed approach was applied to typical examples and showed sufficient accuracy when compared to the evaluated leakages based on the corresponding AWNs. Wrinkle density is recommended to be modeled as random field.     

电磁场作用下球形磁极辅助研磨弯管内表面研究

弯管弯曲成形后,在弯折处易产生微裂纹、褶皱等表面质量缺陷问题。本文通过采用六自由度机械手拖动电磁场发生装置沿加工轨迹往复运动,电磁场发生装置驱动球形辅助磁极绕管件内壁转动,实现了对弯管内表面的光整加工。在此基础上,通过对弯管轮廓采集及曲线拟合,重新构建了弯管中心线并转换为新的研磨加工轨迹。采用超景深3D电子显微镜和触针式表面粗糙度测量仪对研磨试验前后弯管内表面的形貌和粗糙度进行了对比分析。结果表明,通过重新构建研磨加工轨迹,试验装置有效解决了研磨弯折处的干涉与研磨不均匀等问题。研磨55 min后,表面粗糙度由原始的0.713μm降低到0.194μm,铜合金弯管内表面原始质量缺陷基本去除,表面纹理较为致密均匀。该方法有效避免了未规划研磨轨迹时出现的犁耕等纹理缺陷,提高了弯管的服役可靠性。     

雷电通道水平电场影响因素分析

影响雷电通道产生的水平电场因素众多,分析其影响因素对电力系统的雷电防护具有重要意义。文中利用运动电荷电磁场方程求解得到闪电回击通道的水平电场和方位磁场,并结合C-R 算法,得到了有限电导率地面上方的水平电场。依据运动电荷电磁场方程的特征分析了不同回击速度、不同距离、不同电导率对雷击产生的水平电场的影响。得出以下结论:水平电场随回击速度增大而减小;水平电场波形呈双极性特征且水平距离越大或电导率越小负向偏移越明显。这些研究结论为输电线路雷电过电压计算打下良好的基础。与其他方法相比,本文方法可以避免远距离电磁场计算中的震荡问题和积分方程的奇异问题。     

频率可调太赫兹回旋振荡管互作用电路的设计与研究

根据动态核极化核磁共振成像技术对回旋振荡管的要求,设计了130 GHz 回旋振荡管的注波互作用电路,基于线性理论对互作用电路进行了研究并选择了合适的工作点,分析了电路的频率调节特性。利用相对论电子回旋脉塞非线性理论对互作用系统进行了模拟和计算,优化了工作参数,计算了磁场及电子注参数对输出功率及效率的影响。最后,用粒子模拟方法进行了模拟并与非线性理论结果进行了比较,两者符合得很好。模拟结果显示,当电压为10 kV、电流为0.3 A、磁场强度由2.34 T 增加到2.41 T 时,输出功率由1310 W 减小到230 W,对应的效率分别为43.6%和7.7%,振荡管的频率可调范围约为2.7 GHz。     

磁絮凝强化技术处理厌氧消化污泥脱水液

为满足后续生物处理单元对固体悬浮物（SS）和铁浓度的进水要求，采用磁絮凝强化技术对厌氧消化污泥脱水液进行预处理。通过正交试验和单因素试验，本文考察了混凝水力条件、聚合氯化铝（PAC）投加量、聚丙烯酰胺（PAM）投加量、磁粉投加量及药剂投加顺序对磁絮凝效果的影响。试验结果表明：磁絮凝强化技术在快搅300r/min（2min）、慢搅100r/min（15min）、静置10min时，依次投加磁粉（40mg/L）、PAC（30mg/L）、PAM（4mg/L）时处理效果最好。在此运行条件下，SS和Fe³⁺去除率分别为97.61%、98.24%、絮凝指数（FI值）取得最大值、zeta电位绝对值最小，絮凝效果最佳。与对照相比，磁絮凝强化技术对SS和Fe³⁺去除率分别可提高3.70%和10.82%，同时絮体最大沉降速度可提高33%。磁絮凝技术处理后的出水不仅可以满足后续生物处理单元对SS和铁浓度的要求，还可以有效提高磁絮凝体的沉降速度，减小沉淀时间，具有较好的实用价值。     

Precipitation location of secondary phase and microstructural evolution during static recrystallization of as-cast Ti-25V-15Cr-0.3Si titanium alloy

The microstructural evolution and precipitation location of the secondary phase of an as-cast Ti-25V-15Cr-0.3Si titanium alloy were investigated via isothermal compression experiments and heat treatment. The average aspect (length-to-width) ratio, average area and size of the grains at different heat treatment temperatures and holding time were analyzed and the effects of deformation and annealing time on the grain area and size were considered. It was found that the grain size was strongly influenced by the height reduction and holding time. Grain growth was significant when annealing time increased from 10 min to 2 h at 950 °C and height reduction of 30%; however, grain growth was minimal at annealing time between 2 and 4 h. Many dispersion particles were observed to form in continuous chains; the precipitation location was confirmed to be along initial grain boundaries, and the dispersion particles were identified to be Ti₅Si₃ phase by TEM.     

Broadband bowtie belt nanoantennas

In this article, we study a linear array of bowtie nanoantennas placed between two metallic strips that can work from 800 to 1420 nm (600 nm linewidth), with an electric field enhancement factor close to 20. We study the dynamical change of the position of the electric field enhancement amongst different elements in the array and, at the same time, the effects of dispersion on the scalability of the array elements. A systematic analysis and methodology to produce an array that can operate over a large bandwidth whilst maintaining the electric field enhancement without significant variation is provided.     

极端耗水层带精准识别和调堵新技术

油田注水开发后期,部分油层存在极端耗水层带,存在耗水量大,注水驱油效率低,水循环成本高的开发问题,精准认识并有效封堵极端耗水层带,可提高注水利用率。目前国外出现了应用磁性纳米粒子的精细表征新技术及超顺磁性纳米颗粒封堵新技术,抑制极端耗水,实现低成本、高强度、深度堵调。